is seeking certified and qualified DBE subcontractors and/or suppliers to provide Stewart Engineering Inc. is requesting quotes from all qualified subcontractors and suppliers including certified DBE, MBE, WBE, and MB firms. Services needed but not limited to: the following work; Lead Compliance Plan, Develop Water Supply, Construction Area Signs, Traffic Control System, Type III Barricade, Traffic Drum, Portable Changeable Message Sign, Job Site Management, Stormwater Pollution Prevention Plan, Stormwater Annual Report, Temporary Erosion Control Blanket, Move-in/Move-Out (Temporary Erosion Control), Temporary Hydraulic Mulch (Bonded Fiber Matrix), Temporary Cover, Temporary Check Dam, Temporary Drainage Inlet Protection, Temporary Fiber Roll, Temporary Silt Fence, Tempoarary Construction Entrance, Street Sweeping, Temporary Concrete Washout, Asbestos Compliance Plan, Treated Wood Waste, Contractor-Supplied Biologist , Remove Concrete Block, Relocate Worker Memorial Sign, Clearing and Grubbing, Roadway Excavation, Structure Backfill (Culvert), Roadside Clearing, Packet Fertilizer, Slow Release Fertilizer, Plant (Group K), Plant (Group A), Sod, Plant Establishment Work, Gravel Mulch, Decomposed Granite, Wood Mulch, Decorative Pilaster, Concrete Seat Wall, Precast Concrete Split Rail Fence, Pet Fountain and Dry Well, Pet Waste Station, Trash Receptacle, Remove Irrigation Facility, Control and Neutral Conductors (Armor Clad), 1” Remote Control Valve, 2” Remote Control Valve, 24-32 Station Irrigation Controller (Wall Mounted), 2” Backflow Preventer Assembly, Backflow Preventer Enclosure, Pop-Up Sprinkler Assembly (Gear Driven), Riser Sprinkler Assembly, 2” Gate Valve, 1” Plastic Pipe (Schedule 40)(Supply Line), 1 ½ ” Plastic Pipe (Schedule 40)(Supply Line), 2” Plastic Pipe (Schedule 40)(Supply Line), Ball Valve, PVC Pipe Conduit, PVC Pipe Conduit (Sleeve), Relocate Boulder, Fabricated Display Panel, Picinic Table, Bonded Fiber Matrix, Fiber Rolls, Compost, Incorporate Materials, Class 2 Aggregate Subbase, Class 2 Aggregate Base, Cement Treated Permeable Base, Hot Mix Asphalt (Type A), Tack Coat, Cold Plane Asphalt Concrete Pavement, Structural Concrete Drainage Inlet, 24” Reinforced Concrete Pipe, Drainage Inlet Marker, 24” Alternative Flared end Section, Abandon Culvert, Remove Culvert, Remove Inlet, Sand Backfill, Rock Slope Protection (60 Lb, Class II, Method B), Rock Slope Protection Fabric (Class 8), Minor Concrete, Detectable Warning Surface, Minor Concrete (Gutter Depression), Minor Concrete (Concrete Mow Strip), Minor Concrete (Sidewalk), Minor Concrete (Curb Ramp), Remove Concrete Curb, Remove Concrete Sidewalk, Miscellaneous Iron and Steel, Paint Curb (2-Coat), Obliterate Surfacing, Tube Steel Fence, Tube Steel Gate (8 ft), Tube Steel Gate (20 ft), Remove Pavement Marker, Pavement Marker (Retroreflective), Marker (Culvert), Treatment Best Management Practice Marker, Remove Roadside Sign, Remove Roadside Sign (Strap and Saddle Back Method), Furnish Single Sheet Aluminum Sign (0.063”-Unframed, Furnish Single Sheet Aluminum Sign (0.080”-Unframed, Furnish Single Sheet Aluminum Sign (0.063”-Framed, Furnish Single Sheet Aluminum Sign (0.080”-Framed, Roadside Sign-One Post, Roadside Sign-Two Post, Install Sign (Strap and Saddle Back Method), Thermoplastic Pavement Marking (Enhanced Wet Night Visibility), 6” Thermoplastic Traffic Stripe Marking (Enhanced Wet Night Visibility), Remove Traffic Stripe (High-Pressure Water Blasting), Building Work.
CONSTRUCTION ON STATE HIGHWAY IN COLUSA COUNTY NEAR MAXWELL AT THE MAXWELL SAFETY ROADSIDE REST AREA. Building work, minor concrete, & concrete seat wall.
Contract No. 03-0J4604
State of California, Department of Transportation
MAXWELL SAFETY ROADSIDE REST AREA-03-Col-5-R24.3, Maxwell, CA, 95955
10-30-2025 at 02:00 PM
Renee Thomas
(530) 244-8464
(530) 244-8462
P.O. Box 990010, Redding, CA, 96099
PROJECT DETAILS:
Stewart Engineering Inc. is an Equal Opportunity Employer and will work with suppliers and subcontractors to identify opportunities and break down items into economically feasible units as reasonably necessary.
Stewart Engineering Inc. will be bidding the referenced project as a prime contractor. Plans and specifications for this project may be viewed at your local builders exchange and are available for review in our office. If you require additional information regarding the requirements of the contract, please don’t hesitate to contact our office. In order that we may give your bid maximum consideration, please supply us with a fax or email letter prior to the bid describing the scope of your work.
Stewart Engineering is signatory to the Labors Union Local 185, Pile Drivers and Operators Union Local 3. We encourage and actively solicit proposals from DBE subcontractors and suppliers on all our projects. All qualified DBE subcontractors must be registered and certified by the California Department of Transportation. Prior to the bid, upon request, you can contact our office if you require assistance in bonding, lines of credit, insurance, obtaining necessary equipment, supplies, materials or services etc., which may be required by the Owner. Subcontractors must possess a current contractor’s license, worker’s compensation and insurance coverage during the entire length of the prime contract. All Subcontractors will be required to sign our standard Subcontract Agreement (AGC Long Form Standard Subcontract). If you require an advance copy to of the subcontract to look over please contact our office. You must be registered and provide your Department of Industrial Relations number.
